• Standard flange facing finish (MSS SP6) [ BACK ]

▩  STOCK FINISH   The most widely used of any gasket finish, because, practically, is suitable for all ordinary service conditions. This is contonuous spiral froove. Flanges sizes 12" and smaller, are produced with a 1/16" round-nosed tool at a feed of 1/32" per revolution. For sizes 14" and larger, the finish is made with 1/8" round-nosed tool at a feed of 3/64" per revolution.

▩  SPIRAL SERRATED OR PHONOGRAPHIC   This finish is produced by using a 90° included-angle [V] tool, making a spiral groove 1/64" deep of 1/32".

▩  CONCENTRIC SERRATED   This finish a produced by using a 90° included-angle [V] tool, making concentric groove 1/64" deep and 1/32 apart.

▩  SMOOTH FINISH   This finish is produced by several shapes of tools cutting at speeds and feeds which leave no definite tool marks apparent to the naked eye.   1. RAISED FACE, AND LARGE MALE AND FEMALE Either a serrated-concentric or serrated-spiral finish having from 30 to 55 grooves per inch is used. The cutting tool empolyed has an approximate 0.06 in. or larger radius. The resultant surface finish has a 500 microinch (12.5 ㎛) approximate roughness. 2. TONGUE AND GROOVE, AND SMALL MALE AND FEMALE The gasket contact surface does not exceed 125 microinch (3.2 ㎛) roughness. 3. RING JOINT The inside wall surface of gasket groove does not exceed 63 microinch (1.6 ㎛) roughness. 4. BLIND Bland flanges need not be faced in the center if, when this center part is raised, its diameter is at least 1 in. smaller than the inside diameter of fittings of the corresponding pressure class. When the center part is depressed, its diameter is not greater than the the inside diameter of the corresponding pressure class fitting, Maching of the depressed center is not required.